IMPORTANT NOTICE REGARDING YOUR ORDER CLOSE
Seneca Woodworking SWD7IG04 Imperial Thickness Gauge for DF 700 (Requires Domi-Shim)

Seneca Woodworking SWD7IG04 Imperial Thickness Gauge for DF 700 (Requires Domi-Shim)

Seneca Woodworking
$73.95
Part Number: SWD7IG04
Stock: 0
IN STORE PICK-UP AVAILABLE
Choose store location during checkout, ready in 1 to 2 days
Seneca Woodworking SWD7IG04 Imperial Thickness Gauge for DF 700 (Requires Domi-Shim)
The Seneca Woodworking Imperial Thickness Gauge for the Festool Domino DF 700 allows you to quickly and effortlessly adjust the Domino fence offset to center your mortise on a variety of imperial material thicknesses. The gauge installs in less than a minute using a Torx T10 bit (not included), and is a direct replacement for the metric thickness gauge included with your Domino DF 700. The Imperial Thickness Gauge is CNC machined from Delrin material and designed to center on 1/2in., 5/8in., 3/4in., 7/8in., and 1in. nominal ply thicknesses.

**NOTE!** This gauge requires one of our Domi-Shims to function properly. The Domino DF700 fence has a lower travel limit that would normally prevent it from centering on 1/2in.. 5/8in. or 3/4in. ply so a shim is required to enable centering on these thicknesses. The Imperial Thickness Gauge for DF700 is designed to work with the 1/2in. Seneca Woodworking Domi-Shim. We sell the Imperial Thickness Gauge two ways: In a set with the required shim, and by itself for people who already own the Seneca Woodworking Domi-Shim set. The D7IG04 Imperial Thickness Gauge will not work properly without this required shim installed.

Related Items

Recently Viewed Items